save to pc

Discuss the CreatiVision hardware: models, revisions, fixing, hacking and modding.
User avatar
Posts: 502
Joined: Fri Jun 13, 2008 7:39 am
Location: Västerås, Sweden

Re: save to pc

Post by carlsson » Wed Dec 11, 2013 12:52 pm

Yes, the mmbeeb interface supposedly does about 10 kB/s:

It means a 30 kB program might take 3-4 seconds to load. I understand 30 kB is a sneeze in the wind on the GameCube (?), but on the CreatiVision it would equal the largest known software. :D
Posts: 172
Joined: Tue Oct 22, 2013 6:59 pm
Location: Glasgow, Scotland

Re: save to pc

Post by @username@ » Wed Dec 11, 2013 2:49 pm

Thinking further, does soemone with CV hardware knowledge have information on the GPIO pinouts? This would make it easier to connect than centronics, and open up the world of Arduino, Pi etc. Also, GPIO would allow you to write your own protocol which fits with 6502 better.

Just a thought.
˙uʍop-ǝpısdn sı ɹoʇıuoɯ ɹnoʎ 'sıɥʇ pɐǝɹ uɐɔ noʎ ɟı

The creatiVision Emulator 16.04.24
Salora Manager / Laser 2001 BLOAD utility 0.9
CSL Cartridge middleware
Post Reply