Page 1 of 1

Map Scroll Demo

Posted: Fri Apr 12, 2013 10:56 am
by Mobsie
Hi,

here is a first view to my map-engine.
I only have made a little stupid map, so please don`t expect to much.

You can scroll with the joypad around.
I have no border-check at the moment because i work on another game, so when you scroll over the border you see wild chars.

I finish all my routines at the moment, some are very very old, then i begin to write some games.

Re: Map Scroll Demo

Posted: Fri Apr 12, 2013 11:35 am
by MADrigal
It would be nice to also have the source code :)

Re: Map Scroll Demo

Posted: Fri Apr 12, 2013 11:39 am
by Mobsie
yes, soon i upload a new version with source code.

Re: Map Scroll Demo

Posted: Mon Apr 22, 2013 5:28 pm
by carlsson
It looks good!

Re: Map Scroll Demo

Posted: Tue Apr 23, 2013 10:17 am
by Mobsie
Thank you Carlsson,

is just the beginning, and i am a little bit slow after 20! years without 6502.

But i work on some interesting (i hope) stuff.

Re: Map Scroll Demo

Posted: Thu May 09, 2013 3:17 pm
by carlsson
I'm sorry to say the demo doesn't display 100% on my unit. Remember the same type of EPROM, same Diagnosticart and same Creativision unit was earlier today tested working fine with original VTech software, but somehow having issues with homebrew so far.

This one was mostly OK, only a few pixels missing:
Image

Here are four stages of errors, occuring after each time I press the reset button:
Image

Re: Map Scroll Demo

Posted: Thu May 09, 2013 4:03 pm
by Mobsie
thank you for the test.
then we must check 2 points:

1 what exact do the CV at the startup?
2 what to the CV when we press reset?

we don`t handle, i do not, the reset button.

I use the same sort of programming on other hardware with TMS, and all is fine on real hardware.

Re: Map Scroll Demo

Posted: Thu May 09, 2013 4:14 pm
by Mobsie
i think is the screen active bit.
When i start the map-demo i begin to copy all to the VDP, like Kurt.

But i don`t set screen OFF, so maybe i lose some pixel.

And then after every reset, the software start again and do the copy again.
But now the TMS has more to do because the demo is running, and so this time we lose more at the copy.

Maybe try with set the screen to off at the init, like Kurt.

I can`t test because i have no epromer, but you with your game can.

The errors in my map-demo comes when you reset, not when you scroll. and i copy only again when you scroll. So it must happen at the initial VDP copy.

Sorry for my strange english!

Re: Map Scroll Demo

Posted: Sat May 25, 2013 9:31 am
by MADrigal
Just a quick update.

I'm testing Mobsie's demos on a daily basis, and the demo is slowly becoming a GREAT videogame. I would bet a million euros that it'll be by far the most beautiful CV game around! :-)

Let's support him! :-)